Search SLIPNOT

Galvanizing guidelines.

SLIPNOT provides all galvanized steel products in accordance with ASTM A123. Listed below are suggestions and guidelines for galvanizing SLIPNOT steel products. However, if the SLIPNOT surface is galvanized by a third party the guidelines and suggestions must be observed below.

Standard
ASTM A123
Ambient HCl
10 min max.
Heated sulfuric
3 min max.
Recommended galvanizer
SLIPNOT

If a third party galvanizes

Recommended

  • Use ambient-temperature hydrochloric acid, and keep pickling under ten minutes.

  • Hold the zinc bath at a constant temperature.

  • Shot or sand blast any added steel (stringers, support angles, stiffeners) before galvanizing, and make sure it's de-scaled and rust free.

  • Space pieces apart on the rack so the pickling heat does not create hot spots.

  • Keep material inside and wrapped so surface rust cannot form.

Not recommended

  • Leaving material in acid pickling for more than ten minutes.

  • Using a heated sulfuric acid immersion for more than three minutes.

  • An inconsistent zinc bath temperature.

  • Supplying greasy, scaly or rusty material to the galvanizer.

  • Exposure to the elements before galvanizing.

  • Drilling or welding after galvanizing.

Disclaimer

If the SLIPNOT surface is galvanized incorrectly, the surface can be compromised. Traction Technologies Holdings, LLC is not liable for damage to the SLIPNOT surface by third parties, or for replacing or repairing material drilled or welded after galvanizing.

Pieces damaged in material handling must be repaired in the field. Surfaces that are not repaired and protected will fail prematurely.

Want to test first? Ask for galvanized samples.

Get a quote

Tell us about your project, upload your drawings or specs and our safety experts will build a custom quote for you.

Get a sample

See and feel the surface before you specify it. We will send a sample in the metal and finish you are considering.